How to use the Pairs Function in the ROTOR(+) Software (Video)

Introduction : 

The ROTOR software for both the ROTOR HDA and ROTOR+ is very easy to use. The following videos demonstrate the use of the Pairs Function for each version of the ROTOR.

'Pairs' allows the user to repeat pin from the same position on the source plate to the same position on the target plate

Please Note : This video was created without a connection to a ROTOR so it is showing as being offline. The ROTOR(+) should be online (connected) when using these features.

Video

ROTOR+ (August 2021 to present)

ROTOR HDA (2006 to August 2021)

If you require more information please contact [e-mail] for assistance.