Answer : In the software, there is an option to move the pinning position of the plate on the Source Plate only.
This is to allow for variations that may have occurred if the plates were pinned by a different robot or even by hand. It will only move the pick-up position in the X and Y direction and cannot correct rotation.
Note: This also applies to the ROTOR+ although the software has a more modern look.
Please see the attached file which explains in detail how to use the Permanent Offset Option. It can also be found in the videos found in ROTOR Software - Advanced .
If you require more information please contact technicalsupport@singerinstruments.com for assistance.
Comments
0 comments
Please sign in to leave a comment.