Ian
- Total activity 795
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 586
Articles
Recent activity by Ian-
Singer Instruments Technical website - General Information
New Website - 2021 Our Technical Website was updated in 2021. We hope that the new website will provide a better experience for our customers. Sign in While a lot of articles are visible without s...
-
How to sample from one source plate to multiple target plates without returning to source (dilution) on the ROTOR(+)?
Answer : This is a simple job to do on the ROTOR(+). It uses the Recycle options in the ROTOR(+) Software. Please see below for full instructions Please check the first video in this article : A de...
-
Why doesn't the PhenoBooth+ image multiwell plates?
Answer : The PhenoBooth struggles with multiwell plates. It is not designed for this sort of imaging. The reason is the perspective issue on the plate, the distance of the camera makes them look li...
-
Is there a way of imaging bioluminescent colonies? i.e. can you turn off lighting and image on the PhenoBooth(+)?
Answer - Yes. You can turn the internal lighting off in the PhenoBooth(+). In the darkness, it assumes the guide rails are in the last detected position when the lights were on so that it can de...
-
How to load a Stinger Parameter File (Video)
Introduction The Stinger will have been supplied with a data key containing the parameter settings. This should be kept safe as it can be used to restore the parameters. If the parameter file for t...
-
Where do all the connectors attach to the Touchscreen Computer on the ROTOR?
Answer : The image below shows an example of the connections on the bottom of the TouchScreen (MCI) Computer on the ROTOR. The USB/ESB ROTOR connection should be plugged into a USB 3.0 port (Blue)....
-
How to attach the ROTOR(+) Airline (Video)
Answer : This video demonstrates how to attach and remove the airline to the ROTOR and ROTOR+ Note: The same method applies to customers with a compressor or mains air. ROTOR+ Air Connection - ...
-
Singer Lab Support
Introduction Singer Instruments has a long-standing reputation for fantastic service and support, for which we are very proud. Our motto, ‘a responsibility to science’, extends to our service and s...
-
What matrix protocols are available for the ROTOR(+)?
Answer : There are a few matrix routines/protocols available which are explained on the Singer Instruments Website High-throughput Cell Plating application note The matrix protocols are special rou...
-
MK1 Micromanipulator Demonstration (Video)
Demonstration Video : The video below demonstrates the capabilities of the MK1 under a microscope. If you require more information please contact technicalsupport@singerinstruments.com for assis...