Ian
- Total activity 820
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 602
Articles
Recent activity by Ian-
Can any of the Singer Products be placed in an anaerobic chamber?
Answer: The short answer to this question is Yes! However, customers who plan to put their product in an anaerobic chamber should consider the following before deciding if this will work for them. ...
-
How to use the Pairs Function in the ROTOR(+) Software (Video)
Introduction : The ROTOR software for both the ROTOR HDA and ROTOR+ is very easy to use. The following videos demonstrate the use of the Pairs Function for each version of the ROTOR.'Pairs' allows ...
-
How do you use a syringe with a MK1 Micromanipulator?
AnswerTo use a syringe with the MK1 it is assumed that you will be operating the syringe remotely and using our needles holder and tubing to connect to the syringe in question. It will not be possi...
-
Copying 3 Source Plates to 1 Target Plate on the ROTOR?
Answer:The file _d_1_To_3_Array.srr attached to this article allows the user to copy 3 source plates to 1 target plate in a standard format. Eg. 3 x 384 : 1 x 1536The routine is not supplied as st...
-
Recognise your MSM Manual
Picture : Below is a picture of the MSM Manual.Singer Instruments are no longer able to fully support the MSM Manual due to the lack of available parts. If you do experience any problems please con...
-
Tetrad Dissection - Quick Start Guide
Hints & Tips: The attached PDF Guide provides a series of steps that act as a reminder to those who have experienced the difficulties of successful tetrad dissection. It may also serve as a teachi...
-
MSM 400 User Guide
User Guide: The latest User Guide for the MSM 400 is attached to this article. If you require more information please contact technicalsupport@singerinstruments.com for assistance.
-
What are the Automatic Offset Pinning Locations in the ROTOR(+) software?
Answer: When using Automatic Offset the following diagram displays the pinning positions on the source colony each time it returns to the source plate.If you require more information please contact...
-
Air gaps and Blow outs
Answer A travelling Air gap is the volume of air added after the aspirate to prevent any sample dripping. A Blow out is the volume of air added before the aspirate to ensure the target volume is di...
-
What is Liquid Level Tracking (LLT)?
Answer As SQWERTY aspirates Liquid Level Tracking (LLT) will cause the tip to gradually move downwards to maintain the depth as constant. The position the tip is in after the aspiration is then set...