Ian
- Total activity 795
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 586
Articles
Recent activity by Ian-
How to change the screen resolution in the ROTOR HDA Software (Video)
Introduction The screen resolution for the ROTOR HDA can be changed depending on the laptop or touchscreen computer being used. Note: This article only applies to ROTOR HDA's supplied before July ...
-
How successful is the 6144 density on the ROTOR(+)?
Answer : There are a few Singer Instruments customers who have been successfully pinning at 6144 density with the ROTOR. Laboratories that use this method grow the 6144-density plate for a shorter ...
-
Is there a risk analysis available to warn employees of the dangers posed by the ROTOR(+)?
Introduction Risk Analysis for the ROTOR(+) should be undertaken by the customer's own Health and Safety Department based on the following information. ROTOR HDA: The ROTOR has many safety protecti...
-
Where to purchase a replacement UV Tube for the ROTOR(+)
Answer : Replacement UV tubes are no longer kept in stock by Singer Instruments. They can be purchased from Amazon here : G30T8 - 30 watt T8 Ultraviolet UV Tube 36" Length Medium Bi-pin Base or eBa...
-
Where can I find the Compressor Manuals for the ROTOR(+)?
Answer : Since the release of the ROTOR in 2005/6 we have supplied 5 different compressors. Manuals for these compressors are left with the ROTOR during commissioning but we appreciate that they a...
-
What fuses are used in the ROTOR?
Answer : The table below lists the fuses used in the ROTOR please contact Singer Instruments for fitting instructions. A selection of these fuses is included in the ROTOR toolkit supplied with the ...
-
Can the computer (MCI) be fitted to either end of the ROTOR(+)?
Answer : The ROTOR touch-screen computer and even the older ROTOR's with laptop shelves can be easily fitted to either end of the ROTOR. Note: It is not as easy to move the TouchSCreen Computer to ...
-
Can I use deep well plates (eg. 2.2 ml) in ROTOR(+)?
Answer : It is not possible to use 2.2ml deep well plates in the ROTOR (pre-2021). This is due to height restrictions inside the ROTOR. The ROTOR+ will accept the deep well plates. It still uses th...
-
Can I use low profile multi well plates on ROTOR(+)?
Answer : These plates are not high enough to enable the ROTOR(+) to be able to operate normally however there is no reason why they can not be used if required. The gripper head which holds the pad...
-
Does the ROTOR(+) have inbuilt air filters? eg. Hepa Filter
Answer : The ROTOR does not come with an inbuilt air filtering system. As standard, the ROTOR is fitted with UV sterilisation and a protective screen. Although not sealed this does prevent most air...