Adjust Pad Eject Time - ROTOR

Ian -

Some customers experience problems where the pad is not dropped into the dump drawer at the end of a sequence.

This can be due to:

  • Sticky pads
  • Sticky Gripper cord (seal)

If neither of these appear to be the problem then the delay (eject time) over the dump drawer can be increased. This video shows how to adjust the time. Please bear in mind that times are in milli-seconds so this increase in time is unlikely to slow your experiment down by much. You may find that with trial and error you can find an ideal position to suit your ROTOR.

Please Note :

  1. This video shows a mouse cursor for ease of understanding. Use of the touchscreen will work just as well.
  2. You will notice "Offline" shown in the bottom corner of the video. This will not be present shown when following the procedure on the customer ROTOR.

 

 

Can't see the video??

Go Here

Have more questions? Submit a request

Comments

Powered by Zendesk